Technical Features - Jacuzzi experience ENJOY Vorinstallationsblatt

It is the responsibility of the installer/owner to ascertain
compliance with specific local regulations prior to installa-
tion.
Jacuzzi Europe S.p.A. gives no guarantee in this respect
and refuses all responsibility regarding compliance of the
installation carried out.

Technical Features

i
Enjoy Experience ( 1) includes:
- a control unit, called "Spa-Pak"
it is possible to additionally add a spa-pak "booster kit"
NOTE:
i
(optional,
2-2a-3-3a
supplied as standard; refer to the relative documentation.
- the compensation tank (
required to hold water that overflows when users get into the tub.
Its nominal capacity is 1,000 litres (operating with about 800-850
litres).
i
- the Minipool ( 1, C), is to be connected, with hoses, to the "Spa-
Pak", the compensation tank and the drain.
MAXIMUM ABSORPTION FOR THE SYSTEM
SINGLE-PHASE BASE
• version with heater
Power supply (x)
(single-phase)
Volt Hertz
220-240 ~ 50
• version with exchanger
Power supply (x)
(single-phase)
Volt Hertz
220-240 ~ 50
(k): at 230 V (single phase) - (j): power absorption
(x): see the "electrical preparations" chapter
SINGLE-PHASE TOP
• version with heater
Power supply (x)
(single-phase)
Volt Hertz
220-240 ~ 50 25,5 (k)
• version with exchanger
Power supply (x)
(single-phase)
Volt Hertz
220-240 ~ 50
19,5 (k)
(k): at 230 V (single phase) - (j): power absorption
(x): see the "electrical preparations" chapter
THREE-PHASE TOP
Power supply Total consumption electric heater
(three-phase) (12 kW) +pumps+lights
Volt Hertz Ampere
(*) 50
220 - 240 3~ 45
50
26
380 - 415 3N~
(*): special standard (not valid for Europe)
i
( 1, A) .
) to be connected to the one
i
1, B) which, once connected, is
Total consumption
hydro + filtering + heater (3 kW)
Ampere kW
23 (k) 5,15 (j)
Total consumption
hydro + filtering
Ampere kW
8,8 (k) 1,95 (j)
Total consumption
hydro + filtering + heater (3 kW)
Ampere
kW
5,75 (j)
Total consumption
hydro + filtering
Ampere kW
4,25 (j)
Total consumption only pumps and
lights (heat exchanger version)
kW Ampere
(j)
17 13
(j)
17 8
(j): max. power absorption
WEIGHTS
MINIPOOL
net weight
kg
~ 250
area involved
m 2
6,25
LOWERED
RETAINER
TUB
RETAINER
TUB
SPA-PAK
Heat exchanger (optional)
- MAX primary circuit temperature .............................................................50 °C
- Connections.....................................................................................................................3/4"
- Primary circuit flow rate ..............................................................................38 l/min
- Primary pressure drop .....................................................................0,271 m H 2 O
Components
Components and the necessary connections for setting up the system
are described below (see
Minipool and hosing
1 overflow channel with grid
2 pneumatic buttons
2a box for connection of pneumatic buttons
3 low-point drain with gate valve
to the compensation tank (overflow lines)
4A1+4B1
to the compensation tank (overflow lines)
4A2+4B2
5 hydromassage pump suction lines
6 hydromassage pump delivery lines
7 filtering suction line
8 suction line from the compensation tank
9 filtering return line
10 blower line
11 connections to the water system
12 perimeter metal supports
Spa-pak
13 (13a) Electric wiring box
14 optional - 14b: heater or 14a: heat exchanger
15 hydromassage pumps
16 filtering pump
17 blower (where present)
18 quartz sand filter
19 safety switch
20 temperature sensor
21 flow switch (models with heater)
kW
(j)
5
(j)
Compensation tank
5
22 water loading/filling solenoid valve (3/4")
23 level switches
20
average volume
MAX water
of use volume
litres
litres
~ 1700 ~ 2100
average load on area
resting surface
involved
m 2 kg/m 2
376
1,13
max weight
ground resting
at full load
surface
kg m 2
~ 900 ~ 1,8
~ 925 ~ 1,2
~ 285 ~ 1,1
i
2-2a-3-3a).
max. total
weight
kg
~ 2350
concentrated load on
resting surface
kg/m 2
2080
ground
load
kg/m 2
~ 500
~ 770
~ 260