Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
It is the responsibility of the installer/owner to ascertain
compliance with specifi c local regulations prior to installa-
tion. Jacuzzi Europe S.p.A. gives no guarantee in this respect
and declines all responsibility regarding the compliance of
the installation performed.
Technical Features
The Santorini Pro spa (
litres. Its power supply is single-phase (220/240 V), and all its
electromechanical organs and pipes are contained within its pe-
rimeter. It is equipped with two 2-Hp pumps and one recirculat-
ing pump.
The skimmer contains 2 fi ltering cartridges (fi ltering surface: 9.3
m2) which guarantee optimal water fi ltration.
Maximum absorption of the system
•
VERSION WITH HEATER
Power supply
Total consumption electric
(single-phase)
heater + hydromassage
Volt
Hertz
Ampere
220-240 ~
50
30 (k)
•
VERSION WITH EXCHANGER
Power supply
Total consumption
(single-phase)
idro + fi ltering
Volt
Hertz
Ampere
220-240 ~
50
15,5 (k)
(k): at 230 V (single phase) - (j): absorbed power (max 4.7 kW)
The electrical system that powers the spa must absolutely be
sized for maximum consumption (as shown in the table). If suffi -
cient electrical energy is not available, an electronic energy con-
sumption limiter can be activated.
- alternative consumption: 3.6 kW (when 1 hydromassage pump
is run, the electric heater goes off ).
Heat exchanger (optional)
- MAX primary circuit temperature ........................................... 50 °C
- Connections .......................................................................................3/4"
- Primary circuit fl ow rate ....................................................... 38 l/min
- Primary pressure drop ...................................................0,271 m H
Weights
Net weight
average volume
of use
kg
litres
~ 250
~ 1250
area
support
involved
area
2
2
m
m
~ 4,47
~ 4,38
1;
2) has a capacity of about 1250
Blower
(optional)
kW
kW
6,5 (j)
0,7 (j)
Blower
(optional)
kW
kW
3,5 (j)
0,7 (j)
water volume
Total max. weight
MAX
litres
~ 1800
average load
concentrated load
on concerned area
on support area
2
kg/ m
~ 458
User safety
If installed by qualifi ed personnel in compliance with the in-
structions in the enclosed installation manual, the system does
not present any risks for the user. However, safety is also contin-
gent upon appropriate use, according to the provisions in the
respective manual, while the user must delegate the operations
described in the installation manual to qualifi ed personnel.
It is important to make sure that personnel tasked to install
or manage the system are qualifi ed as per legal requirements in
eff ect in the country where installation is carried out.
Arrangement for installation
You can use a garden hose to fi ll the spa.
If the spa is connected, for periodic fi lling, to the
Audio System
mains system that supplies drinking water, this con-
(optional)
nection must be carried out in compliance with the
kW
EN1717 norm, using "AA", "AB" or "AD" anti-pollution
0,5 (j)
protection procedures. For further information, we
recommend you contact your water supply company
and/or your plumber.
Audio system
(optional)
The customer must make provisions for a ground drainage
kW
point of suitable dimensions and that can be inspected for any
0,5 (j)
cleaning that may be required.
ATTENTION: Before preparing the ground drainage
point, consult the local authority for the regulations
that control the drainage of chemically treated water.
(
3, det. B) Especially when installed inside, it is advisable
to connect the connection on the base to the main drain pit. As
there is a large amount of water in the spa, this is a useful precau-
tion if water accidentally escapes and collects inside the base.
- (det. A/B) as an alternative, a collection pit can be provided (P)
under the base of the spa (which will be perforated).
NOTES:
O
- The collection pit will be connected to the main drain pit.
2
- If a quick drain connection is prepared, make sure that the hole
in the base, the collection pit and its connection to the main drain
pit are large enough to permit the passage of the drain hose (see the
drawing in section).
kg
To periodically empty the spa you can (
~ 2050
(det. A) connect a hose to the drain valve, fi rst removing the
plug and screw on the fi tting with its gasket.
NOTE: To open the valve, you must turn the ring nut anticlockwise
2
kg/ m
and pull it, therefore if you decide to connect the spa permanently
~ 468
to the ground drainage point, we recommend you install a valve be-
low, bypassing the valve installed in the factory.
15
15
3):
Werbung
Inhaltsverzeichnis
