User Safety; Technical Features - Jacuzzi J-460 Vorinstallationsblatt

It is the responsibility of the installer/owner to ascer-
tain compliance with specific local regulations prior to
installation.
Jacuzzi Europe S.p.A. gives no guarantee in this re-
spect and refuses all responsibility regarding compli-
ance of the installation carried out.

Technical Features

The MaxiJacuzzi ® Premium feature a single-phase power sup-
ply (220-240 V). All electro-mechanical parts and pipes are
enclosed.
The models of the J-400 range have two hydromassage
pumps and a circulation pump.
Maximum absorption of the system
Power supply
(single-phase)
Voltage Hertz
J-460 50
220-240 ~
J-470
220-240 ~ 50
J-480 220-240 ~ 50
The electrical system that powers the MaxiJacuzzi
solutely be sized for maximum consumption (as shown in
the table). If sufficient electrical energy is not available, an
electronic energy consumption limiter can be activated from
inside the electronics box.
This operation can only be performed by authorized Jacuzzi
technicians and limits electricity consumption as follows:
- medium alternative consumption: 4.8 kW (when 2 hydro-
massage pumps are run, the electric heater goes off).
- minimum alternative consumption: 3.9 kW (when 1 hydro-
massage pump is run, the electric heater goes off).
Weights
net weight water volume
kg
litres
~ 1210
J-460 ~ 338
~ 393
J-470 ~ 1552
~ 431 ~ 1703
J-480
area involved support area
m 2 m
~ 4,22 ~ 3,44
J-460
J-470 ~ 5,48 ~ 4,60
J-480 ~ 5,48 ~ 4,60
Tot. Consumption: electric (k): 230 V
(single-phase)
heater + pump(s)
Ampere kW
(j): max. power
absorption
(k) (j)
29 6,7
(k)
(j)
29
6,7
(k)
(j)
29
6,7
®
max. no. total max.
of people
n
6 ~ 2028
6 ~ 2425
6 ~ 2614
average load load concentrated
on area involved
on support area
2 kg/m 2
~ 480 ~ 589
~ 442 ~ 527
~ 477 ~ 568

User safety

I
The system, if installed by qualified personnel, does not present
any hazard for the user. Safety is however also contingent upon
proper use, as set forth by the user's manual included with the
product. The user must contact qualified personnel for special
operations described in the manual.
I
It is important to make sure that personnel tasked to install and
manage the system are qualified as per legal requirements in
effect in the country where installation is carried out.
I
Periodically, however, the differential switch (see "ELECTRICAL
SAFETY" chapter) of the system to which the mini-pool is con-
nected must be checked for efficiency. When you press the
TEST key, the switch must disconnect. If this does not
happen, disconnect the power supply immediately and
contact a qualified technician.
I
For any extra maintenance and/or repairs it is recommended that you
contact an Authorized Service Centre and use only original spare parts.
Set up for installation
I
MaxiJacuzzi
i
in 1-1a-1b, detail A.
The customer must make provisions for a ground drainage point
must ab- of suitable dimensions and that can be inspected for any cleaning
that may be required.
ATTENTION: Before preparing the ground drainage
point, consult the local authority for the regulations
®
that control the drainage of chemically treated water.
I
For periodic emptying of the MaxiJacuzzi
rubber hose to the drain valve (
NOTE:To open the valve, turn the ring nut counter-clockwise and pull.
If you decide to attach the MaxiJacuzzi to the drain, it is advis-
able to connect upstream from the valve (for greater flow capac-
ity) and to install a shutter valve near the drain in an accessible
i
area (
I
According to the type of installation chosen the ground drainage
point will then be put into position.
weight
kg
installed in a variety of ways:
- Free standing on the floor or on a specifically prepared base
i
( 4).
- Semi-built in, so that only the base of the MaxiJacuzzi
kg/m 2
built-in and therefore the side cover panels remain free(
In this case, it is appropriate to prepare some removable under-
frames (in marine plywood, etc.) that, besides aesthetically com-
pleting installation, allow the panels to be removed more easily.
I
In any case you will need to provide a support base that is suit-
able for the selected model, taking into consideration the data
contained in the table "Weights".
12
® Premium
are equipped with the drain arranged as
i
1-1a-1b, detail A).
1-1a-1b, detail A1).
MaxiJacuzzi
® you can connect a
® Premium can be
® is
i
5).