Eléments De Commande; Care And Maintenance - Conrad Electronic WS 1600 Bedienungsanleitung

Eléments de commande
Symbole de piles
déchargées Symbole d'alarme de réveil
Affichage de l'heure
Fraîcheur du vent (Wind
Chill) en °C ou °F
Température extérieure
en °C ou °F
Symbole pour tempéra-
tures extérieures
Pression atmosphérique
relative en hPa ou inHg
Histogramme de l'histo-
gramme de la pression
atmosphérique
Affichage de piles
déchargées de l'émetteur
extérieur
74
Affichage du calendrier
Affichage pour vibreur
ARRET (OFF)
Affichage de la direction
du vent et de la vitesse du
vent sur l'échelle Beaufort
Symbole pour alarme de vitesse
de vent HI/LO
Vitesse du vent en km/h, mph ou m/s
Humidité relative de l'air extérieur en %
Symbole pour alarmes d'humidité
de l'air extérieur
Quantité totale de pluie en mm ou
en pouces
Affichage de la tendance météo
Symbole de prévision météo
Symbole de réception du signal de
l'émetteur extérieur
Support rabattable I
Oeillet d'accrochage
Couvercle du logement des piles
Support rabattable II
When the rain sensor is securely mounted, connect its cable with the right socket of
the thermal hygro outdoor sensor.
Now the rain sensor is ready for operation. For test purposes, carefully and very
slowly pour in a slight amount of clean water into the funnel of the rain sensor. This
water quantity is now measured like normal rain. The measuring result should be dis-
played on the basis after approx. 2 minutes.
The wind sensor
Weather flag
Horizontal instal-
lation surface
First, guide the connection cable through the mount of the wind sensor. Check
whether the wind flag and the wind wheel can turn free and easily. For correct and
accurate measuring, it is important to mount the wind sensor in such a way that its
front side (marking E) points towards East-West. You can attach the wind sensor with
the enclosed screws or cable clams to a solid wall or wooden post with a diameter of
16 to 33 mm. In any case, make sure that the wind can access the wind sensor on all
sides without restriction. Then connect the connection cable with the correct socket
of the thermal hygro outdoor sensor.

Care and maintenance

Avoid extreme temperatures, vibrations and blows, which may damage the device
and lead to false measuring results.
Use a slightly damp, soft cloth to clean the display and the casing. Do not use any
solvents or abrasive cleaners, which may damage the display and the casing.
Do not immerse the basis in water!
Vertical post
Wind wheel
67