Conrad Electronic WS 1600 Bedienungsanleitung Seite 46

- Fraîcheur du vent maximale (Wind Chill) avec heure et date d'enregistrement
- Pression atmosphérique relative minimale avec heure et date d'enregistrement
Heure et date
de l'enregistre-
ment
Pression atmos-
phérique relative
maximale
Symbole MAX
- Vitesse du vent maximale
Symbole MAX
Réinitialisation des données météo maximales et minimales
Pour la remise à zéro des données météo maximales et minimales précédemment
décrites 1 à 9, l'utilisateur doit réinitialiser chaque affichage séparément !
Appuyer sur la touche MIN/MAX pour afficher les données météo voulues ! Si l'utili-
sateur souhaite p. ex. réinitialiser la valeur d'humidité de l'air minimale, il doit alors
96
Heure et date de
l'enregistrement
Vitesse du vent maximale
The thermal hygro outdoor
sensor works with 2 mignon
cells of 1.5 V each.
A battery change is neces-
sary when the display shows
the low battery symbol on
the bottom right.
Saved data is
lost when changing the batteries. Therefore you have to make all
settings / programming operations again.
Batteries do not belong in the hands of children.
Make sure that the polarity is correct when inserting the batteries.
The batteries must not be short-circuited nor thrown into the fire
nor reloaded. In these cases, there is a risk of explosion.
Function buttons
The basis has 5 buttons, which have
the following functions:
SET button
Press this button for accessing the manual setup mode for the following functions:
LCD contrast, manual time setting, 12/24 hr format, calendar setting, temperature
display units °C/°F, wind speed, rain quantity, air pressure, reference setting for the
relative air pressure, setting the switching threshold for the weather forecast display,
setting the switching threshold for the storm warning and alarm setting ON/OFF.
In normal display mode, press and hold the button for switching the buzzer ON/OFF.
In weather alarm setup mode, press and hold the button for setting the different
alarm values and for switching the alarm ON/OFF.
Press the button for activating reset mode during the display of the saved maximum
or minimum values.
Stopping the alarm signal when the wakeup or weather alarm sounds.
1. Remove the rain protection from the thermal
hygro oputdoor sensor.
2. Remove the battery compartment cover
3. Insert the batteries observing the correct
polarity (see marking in the battery
compartment).
4. Close the battery compartment cover and
replace the rain protection.
SET button
+ button
HISTORY button
ALARM button
MIN/MAX button
45