64
After successful completion, the display will show the following:
2. Manually starting the regeneration of the water softener:
The water softener has to be in operating mode. The display shows the operating mode (see fig. 9).
Press
. The display will show the following:
Press <OK>. The display will show the following:
Press
or
to change between <yes> and <no>.
When <yes> is selected, the regeneration is started by pressing <OK>.
Subsequently, the display shows "Regeneration".
Regeneration will be completed after approx. 9 minutes. Afterwards, the display again indicates the oper-
ating mode.
The water softener is now ready for operation.
The following parameters must then be set:
/
Raw water hardness (see chapter 6.3.1 "SETTING THE RAW WATER HARDNESS")
/
Blending (see chapter 6.3.2 "SETTING THE BLENDING")
Betrieb
Fig. 9: Operating mode display
Hauptmenü
· Regeneration
Regeneration
Starten <nein>