Test Marks; Safety; Intended Use - Conel CLEAR Serie Montage- Und Betriebsanleitung

51
3.3

TEST MARKS

The water softeners conform to the technical regulations for drinking water installations in accordance
with DIN EN 806 ff. and the national annex DIN 1988 ff. and DIN EN 1717. They are designed according
to DIN EN 14743 and DIN 19636-100 for water softening systems (cation exchangers) in drinking water
installations.
The DVGW certification is requested.
4

SAFETY

4.1

INTENDED USE

Installation and use of the water softener are each subject to the applicable national regulations. In addi-
tion to the operating instructions and the obliging regulations concerning accident prevention that exist in
the country of operation and the location of use, the established technical regulations concerning safe and
professional work, should also be observed.
The water which is to be softened should fulfil the requirements stipulated by European
drinking water directives!
It is absolutely essential that the manufacturer/supplier will be consulted prior to any operation of the de-
vice using water of a different quality, respectively with water that contains additives.
This water softener is suitable for use in cold drinking water up to a maximum water and ambient temper-
ature of 30 °C (86 °F). It is produced to state of the art standards and the generally accepted safety regu-
lations in Germany.
The water softener may only be used as described in the operating instructions. Any other or further use
is deemed not to be intended use.
Additional dangers exist in case of non-intended use and failure to observe the danger symbols and safety
information. The manufacturer/supplier are not liable for any losses or damage resulting from this. The risk
is solely borne by the user.
Intended use also includes observing the operating instructions.
The manufacturer/supplier must always be consulted before using the water softener outside the use lim-
itations given in the operating instructions. The water softeners are only to be used in a technically perfect
condition, for their intended use, safely and aware of the dangers and with full observance of the instruc-
tion manual!
Have any malfunctions corrected immediately!
In order to be able to safely discharge the wastewater in operation and in case of any defect in the system,
precise compliance with the details given in chapter 5.1 "REQUIREMENTS FOR THE PLACE OF INSTAL-
LATION" is necessary!
The regenerating salt used is removed from the water softener columns with the waste-
water. Therefore, it may not be used to water plants or for similar purposes.