Switching Off; Troubleshooting - Silvercrest HG04458A Bedienungs- Und Sicherheitshinweise

Note: You can find the nutritional values of foods on
their individual packaging or in specialist literature.
Switch on the product by pressing the button
ON / OFF . The LC display
6
displays for approx. 2 seconds.
Press the button MR
simultaneously for about 2 seconds until "CODE
800" flashes in the food code display
Enter a code between 800 and 999 which you
wish to save the nutritional and energy values for
a new food by pressing the number buttons
Five nutritional and energy values are needed to
set:
PROT (protein) -> FAT (fat) -> CARB (carbohydrates)
-> KCAL (kilocalories) -> CHOL (cholesterol)
Then, press the button MR
play is now displayed permanently and PROT
13
flashes in the nutritional and energy display
Enter the value for the protein using the number
buttons .
3
Press the button MR
Repeat previous step until all nutritional and en-
ergy values are saved.
After entered all the corresponding nutritional and
energy values, press the button MR
entry of the nutritional and energy values. This
new food will be ready to use.
Note: The following maximum values can be
entered:
PROT (protein):
FAT (fat):
CARB (carbohydrates):
KCAL (kilocalories):
CHOL (cholesterol):
Note: "E" will be showed if the value you enter
exceed the corresponding maximum values.
Note: You can also overwrite one of your previ-
ously saved codes by simply reassigning the code
12 GB/IE/NI
will show all
2
and button UNIT
4 7
.
13
. The food code dis-
4
again to enter next setting.
4
to complete
4
500 g
500 g
500 g
5000
5000 mg
number and saving the new nutritional and energy
values under this code.

Switching off

Pressing the button ON / OFF
If no movement is detected on the weighing surface
for 1 minute and no button is pressed, the product
will automatically switch off.
.
3

Troubleshooting

= Fault
= Cause
= Solution
= 0-Ld
.
11
= The product is overloaded.
= Remove the overload.
=
= The batteries are too weak to weigh. You cannot
operate the product.
= Replace the batteries (see section "Replacing the
batteries").
Note: The product contains sensitive electronic compo-
nents. For this reason it is possible that it can be disrupted
by radio transmitting equipment in the immediate vicinity.
If the LC display
objects away from it.
Electrostatic discharges can lead to malfunctions. In
cases of the product failing to work, remove the
batteries for a short while and then replace them.
will off the product.
6
indicates a problem, move such
2
1