Changing The Measuring Unit; Switching Off; Troubleshooting; Cleaning And Care - Silvercrest HG01939A Bedienungs- Und Sicherheitshinweise

If you remove all items from the product, the LC
display will show a negative value indicated
2
by the minus symbol
Then briefly touch the button
the „Tare" symbol
Important! Be sure never to add more than 5 kg
to the weighing surface
can damage it.

Changing the measuring unit

The product will display the weight in the official Euro-
pean measuring unit „g" (grams), as well as the tradi-
tional unit of weight „oz" (ounce, 1 oz ≈ 28.35 g) or
„lb'oz" (pound: ounce, 1lb = 16 oz ≈ 453.59 g).
When measuring the volume of water, the product
calculates it by the weight using the official European
unit of volume „ml" (millilitres) or the traditional unit of
measure fl'oz (fluid ounces, 1fl'oz ≈ 28.41 ml).
To switch the unit of measure, briefly touch the UNIT
button . After each time it is touched, the unit
4
display will switch to the next unit listed:
7
g → oz → lb'oz → ml → fl'oz

Switching off

Holding the button
will off the product. If no movement is detected on
the weighing surface
is pressed, the product will automatically switch off.
18 GB/IE
.
10
/ TARE , and
3
will disappear.
9
. Overloading the product
1
/ TARE for approx. 3 seconds
3
for 2 minute and no button
1

Troubleshooting

= Fault
= Cause
= Solution
=
= The product is overloaded.
= Remove the overload.
=
= The battery is low.
= Replace the battery (see chapter „Replacing the
battery").
=
= The batteries are too weak to weigh. You cannot
operate the product.
= Replace the battery (see section "Replacing the
battery").
Note: The product contains sensitive electronic compo-
nents. For this reason it is possible that it can be disrupted
by radio transmitting equipment in the immediate vicinity.
If the LC display indicates a problem, move such
2
objects away from it.
Electrostatic discharges can lead to malfunctions. In
cases of the product failing to work, remove the
batteries for a short while and then replace them.

Cleaning and Care

Never immerse the product in water or other
liquids. This can damage the product.
Clean the product with a slightly dampened, fluff-
free cloth. To remove more stubborn dirt, you can
also dampen the cloth with a weak soap solution.