Main Menu Functionality - WIKA CPH65I0 Betriebsanleitung

6. Commissioning, operation

6.1.1 Main menu Functionality

There are three options in this menu: "CONFIG", {active display} and "MORE". The
main menu is the home menu for the menu display.
GB
6.1.1.1 Setting the {active display} parameters
The {active display} is displayed via the middle option in the menu in the main display.
Pressing the F2 key switches between the {active display}.
6.1.1.2 Setting the {active display} parameters
In order to set the {active display} parameters, select the "CONFIG" option and open
the configuration menu.
The "SELECT" option switches between the available choices for each parameter.
Since voltage, current and switch-test modes all use the same leads, two of these
functions cannot be used concurrently. The ability to select certain functions is limited
and dependent upon what is already selected in the other display sector. The "NEXT"
option is used to switch to the second parameter.
Only the resistance thermometer and pressure modes have a second parameter.
Resistance thermometers can be displayed in Celsius or Fahrenheit and for pressure
there are 16 different units.
Within any single display sector, the following modes are available:
P[1]
P[2]
P[1] ST
P[2] ST
mA measurement = current measurement
RTD
22
= left integrated pressure sensor
= right integrated pressure sensor (only for CPH65I0-S2)
= switch test with left integrated sensor.
= switch test with right integrated sensor (only for CPH65I0-S2)
= resistance thermometer (in the event a resistance thermometer
is connected)
WIKA operating instructions, model CPH65I0