Initial Start-Up; Configuring The Motion Sensor; Configuring The Illumination Time (Time); Configuring The Sensor Sensitivity (Sens) - LIVARNO LUX LSS 520 A1 Bedienungsanleitung Und Serviceinformationen

LIVARNO LUX LSS 520 A1

Initial start-up

Turn on the solar LED spotlight (1) using the On/Off switch (2) by putting it into the 'ON' position.

Configuring the motion sensor

Ensure that no places where traffic is common (e.g.,
sidewalks, streets) are located within the motion sensor's (5)
range.
When setting the photosensitivity of the motion sensor (5), you
should do so at a time when the lighting conditions configured
to trigger the solar LED spotlight (1) are prevalent.
 Align the motion sensor (5) so as to ensure maximum coverage of the area to be monitored. This means
that no obstructing objects should be present in the path.
 You can change the horizontal position of the motion sensor (5) by pivoting it.
 If you wish to change the vertical alignment of the motion sensor (5), first loosen the arresting screw (4).
Once the motion sensor (5) is aligned as desired, retighten the arresting screw (4).

Configuring the illumination time (TIME):

Use the TIME knob (11) at the bottom of the motion sensor (5) to adjust the illumination time (approx.
10 sec to 4 min). Turn the TIME knob (11) clockwise (+ direction) to increase the illumination time, or turn
it counter-clockwise (- direction) to reduce the illumination time.
Please note:
In order to minimise battery consumption, set the illumination time to as short a
duration as meets your needs.
The device is preset to an illumination time of approx. one minute.

Configuring the sensor sensitivity (SENS)

Use the SENS knob (10) at the bottom of the motion sensor (5) to adjust the sensor sensitivity. Turn the
SENS knob (10) clockwise (+ direction) to increase the sensitivity, or turn it counter-clockwise (- direction)
to reduce the sensitivity. The higher the sensitivity, the larger the detection range (max. 12 metres).

Configuring the photosensitivity (LUX)

Use the LUX knob (9) at the bottom of the motion sensor (5) to adjust the photosensitivity. This setting
determines what ambient light level will trigger the twilight sensor to turn the solar LED spotlight (1) on or
off.
10 - English