Maintenance/Cleaning; Troubleshooting - LIVARNO LUX LSS 520 A1 Bedienungsanleitung Und Serviceinformationen

Turn the LUX knob (9) clockwise (
conditions.
Turn the LUX knob (9) counter-clockwise (
ambient conditions.

Maintenance/Cleaning

Maintenance
The lamp component of the solar LED spotlight (1) comprises 9 long-life LEDs. These cannot be replaced
and thus do not require maintenance.
Cleaning
Ensure that no liquids enter the housing of the solar LED
spotlight (1) as this might damage the solar LED spotlight (1).
Clean the solar LED spotlight (1) and the solar panel
agents or solvents that react with plastic. If the device is heavily soiled, slightly moisten the cloth before
cleaning.

Troubleshooting

The light does not go on
 The On/Off switch (2) is set to 'OFF'.
 The motion sensor (5) is not properly aligned. Correct its alignment.
 The built-in battery is fully discharged. Ensure that the solar panel (7) is properly aligned, and fully
charge the battery. If necessary, shorten the illumination time to reduce the power consumption. In
order to fully charge the battery, set the On/Off switch (2) to 'OFF' for the duration of the charging
process. After charging is complete, switch the On/Off switch (2) back to the 'ON' position.
The duration of the charging process depends on the intensity of the solar radiation. In sunny
weather, charging takes approx. 3 days (given about 4 hours daily and approx. 60,000 lux).
The light goes on and off in rapid succession
 The sensor is experiencing interference caused by an external light source or bright, reflecting
surfaces. Remove the external light source or the surfaces that cause interference.

direction) to make the motion sensor (5) trigger in brighter ambient

direction) to make the motion sensor (5) trigger in darker
using a soft, dry cloth, and never use cleaning
(7)
LIVARNO LUX LSS 520 A1
English - 11