Start-Up; Adjusting The Motion Detector; Setting The Lighting Duration - LIVARNO LUX IAN 288476 Montage-, Bedienungs- Und Sicherheitshinweise

Insert the product with the ground stake far enough into the ground
so it is firmly seated. Make sure it is firmly placed. Do not use exces-
sive force, e.g. strike with a hammer. This could damage the product.
Align the spotlight into the desired direction. For this, you may need to
slacken the locking screws
the locking screws of the hinge joint again, to ensure a secure hold.
Re-install the fuse for this circuit or switch on at the circuit breaker
(I position) in the fuse box.

Start-up

Adjusting the motion detector

Depending on the pre-adjustments of the motion detector
will switch itself on for a certain period of time as soon as the motion
4
detector detects movement. These pre-adjustments are made using the
9
three controllers on the underside of the motion detector

Setting the lighting duration

Turn the TIME rotary control
clockwise to increase the duration of illumination. The lighting du-
9
ration can be adjusted within a time window of approx. 5 seconds to
7½ minutes.
of the hinge joint. After alignment, tighten
7
on the bottom of the motion detector
19
, the spotlight
9
(Fig. H).
9
GB 13