Troubleshooting Guide - Kenwood MG35 Bedienungsanleitungen

troubleshooting guide

Problem
Meat grinder does not
operate.
Meat Grinder stops or
slows during operation.
Poor minced results.
Ring nut difficult to
remove after mincing
process.
Meat grinder attachment
cannot be removed from
power unit.
Cause
No power.
Stalls due to food
clogging.
Cutter fitted the
wrong way round.
Clogging occurring
behind the screen.
Food forced down
feed tube too
quickly.
Overtightened when Tighten the ring nut firmly by
fitted.
Meat grinder
attachment not
unlocked from
power unit.
9
Solution
Check meat grinder is
plugged in.
Check the fuse/circuit breaker
in your home.
If none of the above see
"service and customer care"
section.
Switch off and turn the
control to R(reverse) for a few
seconds to release clogged
food.
Check cutter fitted correctly
with cutting side facing
outermost.
Switch off and unplug and
dismantle the attachment.
Clean and refit.
Gently guide the food down
the feed tube using the
pusher, one piece at a time.
Allow the scroll to pick up
each piece before adding the
next piece.
hand.
Use the spanner supplied to
undo after use.
Hold the release button down
on the top of the power unit
as you rotate the feed tube
towards the front of the meat
grinder.