Stryker Trio 1033 Betriebsanleitung Seite 21

Operation Guide
OPERATING OPTIONAL FOOT END BACK REST CLAMP−ON SIDERAILS
LEFT
A
RIGHT
NOTCH
A B
WARNING
The clamp−on siderails are only for use with the Foot End Back Rest. Do not use the clamp−on siderails on
any accessory rail other than those on the seat section and do not use the clamp−on siderails with a standard
foot section or the siderail may not be secure and injury could occur.
Do not use the clamp−on siderails on opposite sides of the litter. They are designed to pivot in one direction
and may not provide proper security if used on the wrong side.
To ensure proper security for the patient, after attaching the siderail, be sure to slide it all the way to the end
of the accessory rail until it hits the stop (B) and won't go any farther.
To attach the entire siderail assembly, turn the knob (A) fully counterclockwise to completely loosen it, move
the mattress aside, position the siderail assembly over the notches in the accessory rail, tilt it and pivot the
siderail onto the accessory rail.
Slide the siderail along the accessory rail all the way to the end until it hits the stop (B) and won't go any farther.
Turn the knob (A) clockwise and tighten it securely to hold the siderail in place.
To use the clamp−on siderail, pivot it up and push it down until it locks into the receptacle. Pull the siderail
up and pivot it down to store it.
To remove the entire siderail assembly, turn the knob (A) counterclockwise to loosen it, move the mattress
aside, slide the siderail assembly to the notches in the accessory rail, tilt it and pivot it off the accessory rail.
CAUTION
Do not use the clamp−on siderails as push/pull devices or damage to the rails could occur.
1−18