Before Installation - LIVARNO LUX IAN 288476 Montage-, Bedienungs- Und Sicherheitshinweise

FIRE HAZARD! Fit the product so that it is at least 1.0 m
away from the material to be illuminated. Excessive heat
1 .0 m
can result in a fire.
CAUTION! RISK OF INJURY! Broken lamp glass must
be replaced before any further use of the product.
The product is only suited for use with the built-in LED control gear.
The product continues to draw a small amount of power even if the
lamp is off as long as product is connected to supply mains. To switch
the product off completely, the mains switch should be switched off.
The illuminant is not replaceable.
If the illuminant fails at the end of its life, the entire product must be
replaced.

Before installation

Note: Remove all packaging materials from the product.
Important: The electrical connection must be established by a qualified
electrician or a person trained to perform electrical installations. This person
must be familiar with the properties of the product and the connection
regulations.
Before installation, make sure that no voltage is present on the supply
line to which the product will be connected. To do so, remove the fuse
or switch off the circuit breaker in the fuse box (0 position).
Use the voltage tester to verify the de-energised status.
The included mounting material (screws
able for ordinary solid concrete or masonry construction. Check which
mounting material is suitable for your chosen mounting surface. If nec-
essary, seek expert advice.
10 GB
and wall plugs
3
) is suit-
1