Preparation; Required Tools; Prior To Installation - LIVARNO LUX LSL 32 A2 Bedienungs- Und Sicherheitshinweise

Safety notices / Preparation / Prior to installation / Installation
FIRE HAZARD! Fit the light so that
it is at least 1 m away from the mate-
1m
rial to be illuminated. Excessive heat
can result in a fire.
Broken glass must be replaced be-
fore using the light again.
The bulbs cannot be replaced.
Do not look directly into the light source (light
bulb, LED etc.).
To prevent burns, verify the light is switched off
and has cooled down for at least 15 minutes
before touching it.
Safe working
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and proceed with caution
at all times. Never install the light if you are
having difficulty concentrating or do not feel well.

Preparation

Required tools

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Pencil / making tool
- Voltage tester
- Screwdriver
- Electric drill
- Drill bit
- Screws for wall mounting
- Rawlplugs
- Side cutting pliers
- Ladder
- Spirit level
8 GB

Prior to installation

Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations. This per-
son must be familiar with the properties of the light
and the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box 0 position.
Use the voltage tester to verify the de-energised
status.
When selecting the mounting location, pay
attention to the following:
Ensure the area you wish to light will be lit. The
LED spotlight can be adjusted vertically.
Be sure the motion detector
sired area.
Be sure the motion detector
by other light sources at night, e.g. yard or street
lighting, as this could impair the function.
Installation
Wall mounting (Fig. C)
Prior to installation, remove the fuse or switch
off the circuit breaker 0 setting in the fuse box.
Hold the wall bracket
location you wish to mount it and mark the drill
holes on the wall using the predrilled holes in the
wall bracket . If necessary, use a spirit level.
3
Note: Mount the light at a height of approx.
2.5 m to guarantee full functionality of the mo-
tion detector.
CAUTION! RISK OF INJURY! Please refer
to the operating instructions of your electric drill.
Now drill the mounting holes (ø 12 mm).
Be careful not to damage the supply line.
Insert the rawlplugs into the bores.
Insert the screws (ST8) into the washers.
covers the de-
9
is not impacted
9
against the wall in the
3