Introduction; Intended Use; Delivery Contents; Parts Description - LIVARNO LUX IAN 306755 Montage-, Bedienungs- Und Sicherheitshinweise

LED Ceiling Light With Motion
Sensor

Introduction

Congratulations on the purchase of
your new product. You have chosen a
high-quality product. Please be sure to
carefully read all the instructions for use. Fold out
the page with illustrations. These instructions are
part of the product and contain important information
on setup and operation. Always observe all safety
instructions. Before using this product for the first
time, verify that the correct voltage is available and
that all parts are properly installed. If you have any
questions or are unsure about operating the product,
please contact your retailer or the service centre.
Please keep these instructions in a safe place and
include them when passing this product on to others.

Intended use

This product is suitable for indoor and outdoor use.
The product can be mounted to any surface of nor-
mal flammability. The electrician installing the product
must not install the product on a moist or conductive
surface! This product is intended to be used in private
households only.

Delivery contents

Always check that all the parts are present and that
the product is in perfect condition immediately after
unpacking.
1 LED ceiling light with motion sensor
1 LED lamp (6 W, E27) (not dimmable)
Mounting material (dowels and screws)
1 Instructions for assembly and use

Parts description

LED ceiling light
1
Lamp glass
2
Light fixture
3
LED light bulb (E27)
4
Motion sensor with DIP switch
5
Mains connection cable
6
Cable bridge
7
Mounting holes
8
Light connecting terminal
9
Mains connection cable lead-through opening
10
Seal
11

Technical Data

Item no.: 55002
Operating voltage: 220–240 V∼, 50 Hz
Dimensions:
Light: 27.5 x 11.5 cm (Ø x H)
Detection range: max. 12 m (adjustable)
Detection angle: Ceiling installation: 360 °,
wall installation:150 °
Lighting duration: 5 seconds–max. 30 Minutes
(adjustable)
Ambient
brightness: adjustable; can be
deactivated
Socket: 1x E27, max. 20 W LED
1 LED lamp: 6 W, 2700 K
(warm-white light)
Protection type: IP44

Safety

Safety Notes

Damage due to failure to comply with these instruc-
tions for use will void the warranty! We assume no
liability for consequential damages! We assume no
liability for property damage or personal injury
due to improper handling or failure to observe the
safety instructions!
GB/IE/NI 7