Settings; Configuring The Detection Range; Configuring The Lighting Duration; Configuring Ambient Brightness - LIVARNO LUX IAN 306755 Montage-, Bedienungs- Und Sicherheitshinweise

Settings

You can configure sensor data for each specific
application by selecting a combination on the DIP
switch of the motion sensor.
5
Configuring the detection
range
You can configure the detection range of the
motion sensor in 5 stages using the DIP switch
of the motion sensor.
5
Please note that the maximum detection range
may be reduced the higher the product is in-
stalled.
10 %
25 %
50 %
75 %
100 %
1 2 3
Ⅰ
ON ON ON 100%
ON
Ⅱ
ON ON 75%
Ⅲ
50%
ON ON
Ⅳ
25%
ON
Ⅴ
10%
Configuring the lighting
duration
You can use the DIP switch of the motion sen-
sor to configure the lighting duration of the
5
LED ceiling light
1
Note: The lighting duration refers to the dura-
tion of the LED ceiling light
nation after motion has been detected.
4 5 6
Ⅰ
ON ON ON 5s
ON
Ⅱ
ON ON
30s
Ⅲ
ON ON 90s
Ⅳ
ON 3min
Ⅴ
20min
ON ON
Ⅳ
30min
10 GB/IE/NI
approx. 1.2 m
approx. 3 m
approx. 6 m
approx. 9 m
approx. 12 m
in 6 stages.
at 100 % illumi-
1
Configuring ambient
brightness
You can use the DIP switch of the motion sen-
sor to configure the sensor in 5 stages so
5
that the LED ceiling light
a determined ambient brightness threshold.
If you select the setting "disable" (deactivated)
the daylight sensor of the LED ceiling light
will switch if motion has been detected, irres-
pective of the ambient light (50 lux, 25 lux:
dusk operation, 10 lux, 2 lux: night operation).
7 8 9
Ⅰ
ON ON ON
2lux
ON
Ⅱ
ON ON
10lux
Ⅲ
ON
25lux
Ⅳ
ON
50lux
Ⅴ
Disable

Maintenance and Cleaning

CAUTION! DANGER OF ELECTRIC
SHOCK! Disconnect the light from the power
supply before cleaning. To do so, remove the
fuse or switch off the circuit breaker in the fuse
box (0 setting).
Do not use solvents, petrol, etc. They could
damage the light.
Allow the light to cool down completely.
CAUTION! DANGER OF ELECTRIC
SHOCK! For electrical safety, never clean the
light with water or other liquids, nor immerse it
in water.
Only clean with a dry, lint-free cloth.
Then replace the fuse or switch on the circuit
breaker in the fuse box (I setting).

Disposal

The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities. The Green Dot is not valid for Germany.
Observe the marking of the packaging
materials for waste separation, which
b
a
only illuminates at
1
1