Gaspardo MAGICA Gebrauch Und Wartung Seite 61

5.3.3 TRANSFORMATION from 9 to 8 rows (70-75-80 cm)
Operations to be performed with the machine on the ground.
In order to sow at 70, 75 or 80 cm (Fig. 25), the planting unit
must be modi ed from 9 to 8 planting rows. Remove the central
seeding element, taking care to follow the instructions provided
below (Fig. 27):
(1) Fit the parallelogram stop block in the central element;
(2) With the element in the operating position, completely lower
the equipment to ground level and block the front clod breaker;
(3) Slide out the suction tube;
(4) Disengage the cardan drive shaft of the seeding element;
(5) Remove the screws of the parallelogram and slide out the
seeding element;
(6) Fit the cardan shaft in the support provided and fasten it to the
parallelogram stop block. Place the suction tube in the ring.
If the planting unit is equipped with a microgranulator, proceed
as follows:
- close all the MINIMAX distributors of the central microgranulator
box (Fig. 26);
- Insert the retainer (7) to lock the rack (8), as indicated in gure
26, and loosen the screw (9) to disable the gear.
- remove the left seed drop tube (distribution on central seeding
element);
- move the central tube onto the left distributor;
- open the right and left MINIMAX distributor.
To set interrow spacing at 70, 75 or 80, refer to the diagram
in Figure 24. It is important to remember that to change the
interrow spacing, the upper and lower knuckle pins must be
moved.
1
4
2
cod. G19503301
3
USE AND MAINTENANCE
g. 25
6
g. 26
7
9
5
ENGLISH
8
CLOSED
g. 27
EN - 61