Weekly, By A Trained Operator; Blade Replacement, By A Trained User - JAC SLIM PRO Übersetzung Der Originalanleitung

II. Activate cleaning mode (fig.14)
A. Close the cover.
B. Press the brush at the top right of the display.
C. Press the cleaning pictogram to activate cleaning mode.
The claw and the infeed table will drop down to the lowered position.
D. Open the door.
E. Clean the claw and the cutting channel using a brush.
F. Close the cover and the front door before returning components to the initial position.
III. Cleaning the blade (fig.15,16)
A. Close the cover.
B. Press the brush at the top right of the display.
C. Press the blade cleaning pictogram to activate cleaning mode.
The infeed table will drop down to the lowered position. The blade will position itself in the cutting
channel.
D. Open the door to access the cover unlocking button.
E. Hold down the unlocking button and open the cover.
F. Clean the blade using a damp cloth (always wear cut-resistant gloves when replacing the
blade or when working in the vicinity of the blade).
IMPORTANT: Check the condition of the teeth on the blade. If you notice a deterioration in
cutting quality, it will need to be replaced in accordance with the blade replacement procedure
(§8.3).
G. Close the cover.
H. Switch off the main isolator switch for a few seconds, switch the power on again to the
machine and close the door in order to return the components to their initial position.
8.2

Weekly, by a trained operator.

(fig.17)
A. Open the rear door.
B. Using a paintbrush or any small brush, sweep the crumbs towards the slot between the back
panel and the crumb shield.
C. Vacuum the inside of the machine.
D. Close the rear door.
E. Collect the crumbs in the crumb tray via the front door.
F. Switch off the main isolator switch for a few seconds, switch the power on again to the
machine and close the door in order to return the components to their initial position.
8.3

Blade replacement, by a trained user.

(fig.18)
If you notice a deterioration in cutting quality and tooth wear or if the blade wear indicator (fig.5, n°23)
lights up, follow the steps below.
First of all, activate blade cleaning mode (§8.1.III, A, B, C, D, E).
A. Remove the 5 screws from the blade.
B. Withdraw the blade, pivoting it slightly upwards.
C. Position the new blade and the washer supplied and fit the new screws supplied with the blade.
English
12