Use
Mounting/adjusting the blade guard
WARNING! RISK OF INJURY!
►
Always remove the plug from the power
socket before working on the appliance .
RISK OF INJURY!
►
Always use the angle grinder with the blade
guard
. The blade guard should be fitted
securely . Set it so that the highest possible
degree of safety is achieved, i .e . the smallest
possible part of the grinding disc is open to
the operator . The blade guard
to protect the operator from fragments and
accidental contact with the grinding tool .
RISK OF INJURY!
►
Make sure that the blade guard
least at the same angle as the additional
handle
(see fig . B) . Otherwise, you could
cut injure yourself on the roughing disc or
cutting disc .
♦
Put the protective cover in the position shown
(see Fig . F) .
The protective cover can only be put on or
removed in this position .
Turn the protective cover until it clicks into place
for the first time .
♦
Now pull the lever
cover
into the required position (working
position) until it clicks into place .
♦
Check the secure seat of the protective
cover . The lever
guard
must not twist .
■
10
│
GB │ IE │ NI │ CY
is designed
is fitted at
and turn the protective
must be engaged and the
Fitting the additional handle
CAUTION!
►
For safety reasons, this appliance may only
be used with the additional handle
Failure to do this can lead to serious injury .
The additional handle
onto the left or the right depending on the job
at hand .
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when changing
cutting/rough grinding discs. Roughing and
cutting discs become very hot . Allow them to cool
down completely before touching them .
Pay attention to the dimensions of the roughing/
cutting disc . The diameter of the hole must fit the
mounting flange without any play . Do not use a
reducer or adapter .
■
Check the roughing/cutting disc. It should not
be damaged or damp, and it should have no
cracks. Otherwise, it could break during use
and cause injuries .
NOTE
►
Use only discs which are free of dirt .
■
Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool .
■
RISK OF INJURY! Press the spindle locking
button
only when the mounting spindle
at a complete standstill .
♦
Press the spindle locking button
spindle .
♦
Undo the clamping nut
mounting spanner
♦
Place the rough grinding or cutting disc with the
label side towards the appliance on the mount-
ing flange
.
.
can be screwed
to lock the
using the two-hole
(see fig D) .
PWS 230 D4
is