Safety Of People; Hazards When Using And Handling The Power Tool - Makita SG150 Originalbetriebsanleitung

2.7.3 Electrical safety
•
Before each use, check the power tool,
connection cable and plug for damage.
•
Note the mains voltage! The power source
voltage must match the details given on the
rating plate of the power tool.
•
If using the power tool with mobile
generators, loss of power or atypical
behaviour on switching on is possible.
•
Do not use the power tool if the cable is
damaged. Do not touch the damaged cable
and disconnect the mains plug if the cable is
damaged while you are working.
•
Only use extension cables suitable for the
machine's power consumption and which
have a minimum core cross-section of
1.5 mm . If you use a cable drum, always
2
completely unwind the cable.
•
External electromagnetic interference (e.g.
mains voltage fluctuations, electrostatic
discharges) can cause the power tool to
switch off automatically.

2.7.4 Safety of people

•
Wear personal protective equipment and,
depending on the work situation, use:
Full-face protection, eye protection
or safety glasses/goggles, hard hat
and special apron
Hearing protection
Anti-vibration safety glove
Non-slip safety footwear
Dust mask, half-face filter mask or
face mask respirator
•
If the machine is switched on, do not direct
insert tools towards your own or other
people's bodies. Do not touch or take hold
of the tools.
2.7.5 Hazards when using and
handling the power tool
•
When switching on and while working with
the power tool, hold onto it tightly at both
handles and place your body and arms
in a position in which they can absorb
the kickback forces or reaction torque on
starting up. Always put the machine down
firmly on both rollers.
•
Change insert tools carefully and only use
the mounting tools provided, if they are in
perfect condition. Disconnect the mains
plug before changing the insert tool.
•
After fitting the diamond dry-cutting discs,
before switching on, check that the diamond
dry-cutting discs are fitted correctly and can
rotate freely. Ensure that the diamond dry-
cutting discs do not touch the protective
hood or other parts.
•
Do not expose power tools to extreme heat
or cold.