Cut-Off Machine Safety Warnings - Makita SG150 Originalbetriebsanleitung

EN
2.4 Power tool use and care
a) Do not force the power tool. Use the correct
power tool for your application.
b) Do not use the power tool if the switch does
not turn it on and off.
c) Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools.
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool.
e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use.
f) Keep cutting tools sharp and clean.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed.
2.5 Service
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts.
2.6 Safety Instructions for abrasive
cutting-off operations

2.6.1 Cut-off machine safety warnings

a) The guard provided with the tool must be
securely attached to the power tool and
positioned for maximum safety, so the least
amount of wheel is exposed towards the
operator. Position yourself and bystanders
away from the plane of the rotating wheel.
b) Use only diamond cut-off wheels for your
power tool.
c) The rated speed of the accessory must be at
least equal to the maximum speed marked
on the power tool.
d) Wheels must be used only for recommended
applications. For example: do not grind with
the side of cut-off wheel.
e) Always use undamaged wheel flanges that
are of correct diameter for your selected
wheel.
f) The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool.
g) The arbour size of wheels and flanges must
properly fit the spindle of the power tool.
h) Do not use damaged wheels. Before each
use, inspect the wheels for chips and
cracks. If power tool or wheel is dropped,
inspect for damage or install an undamaged
wheel. After inspecting and installing the
wheel, position yourself and bystanders
away from the plane of the rotating wheel
and run the power tool at maximum no load
speed for one minute.