Keep Your Spa Clean; Winterizing - Jacuzzi J-300 series Montageanweisung Und Bedienung Und Wartung

Keep your spa clean

To preserve the sheen of your spa's surface, it is crucial that
you avoid using abrasive cleaners or cleaners which have ad-
verse effects on the surface.
Regardless of the cleanser used, use extreme care to assure
that no soap residue is left on the surface. This could cause
suds when the spa is refilled.
Pillow Care
C
B
A
Remove and clean the headrest pillows as needed with soapy
water using a cloth or soft-bristle brush.
N.B.: Always remove the pillows when adding chemical shock
treatment to the spa water. The pillows can be returned to the s-
pa when the sanitizer reading drops below 4 ppm.
To remove the pillows:
1. Grasp pillow insert (A) with finger tips and gently pry outward
from pillow base (B).
2. Grasp pillow base (B) with finger tips and gently pry outward
from spa shell (C).
3. Assemble in reverse order after cleaning.
Maintaining the cover
Using the insulating spa cover anytime the spa is not in use will
significantly reduce your operating costs, heat-up time and main-
tenance requirements.
To prolong the life of the cover, handle it with care and clean it
regularly using mild soap and water.
N.B.: Never allow anyone to stand or sit on the cover.
I
Tool Free Access Door
The Tool Free Access door provides fast access to the equip-
ment bay and components without the need of tools. To remove
the door, follow the steps below.
Note: To avoid any injuries, more than one individual must per-
form these steps.
1. Locate the door's retractable push button on the top of the
front panel (1).
2. Press the retractable push button to release the panel door
from the spa frame (2).
3. Slowly and gently tilt the panel forward to remove (3). This
will expose the equipment bay for easy access to the compo-
nents. Place the panel in a safe location to prevent from dam-
aging it.
4.To reinstall the panel just follow the steps above in reverse
order.
1
Panel maintenance
The panels do not require any special maintenance. To clean them,
just wipe them with a clean cloth and a neutral detergent solution.
ATTENTION: do not direct jets of water against the panels,
since electro-mechanical parts are located behind them.

Winterizing

I
Your Jacuzzi ® Premium spa is designed to automatically protect
itself against freezing when operating properly.
I D
uring periods of severe freezing temperatures, you should
check periodically to be certain that the electrical supply to the s-
pa has not been interrupted.
In extreme, bitter cold weather less than 0°C, program the primary
filtration cycle to run for 24 hours to prevent freezing.
I
If you do not intend to use your spa, or if there is a prolonged
power outage during periods of severe freezing temperatures, it is
important that all water be removed from the spa and equipment
to protect against damage from freezing.
For expert winterization of your spa, contact your author-
ized dealer.
In emergency situations, damage can be minimized by taking the
following steps:
- Disconnect the spa from the electric mains.
- Follow the directions for draining the spa.
- Get the water out of the recessed seating areas and footwell.
- Position the massage switch in position A (combo).
32
2
3