Before Addressing A Service Center; Additional Accessories - Redmond RMC-M70 Bedienungsanleitung

Do not use a sponge with a hard or abrasive surface; solvent and abrasive cleaning methods
(gasoline, acetone) are not allowed.
Do not immerse the device in water or wash it under running water.
Clean the housing as needed, following cleaning and general maintenance guidelines pro-
vided. We recommend cleaning inner aluminum lid after each use.
It is recommended to clean the bowl after each use. Dishwasher safe. By the end of cleaning,
wipe the bowl dry.
The steam valve and the inner aluminum lid need to be cleaned after each use.
To clean the inner lid:
1. Open the lid of the device.
2. Simultaneously press 2 plastic holders located on the inner side of the lid.
3. Gently remove the inner aluminum lid by pulling it towards yourself and down.
4. Wipe the surfaces of both lids with wet cloth or tissue. Wash under the running water
using mild soap if necessary. Not dishwasher safe.
5. Place the aluminum lid back into its slots, matching it with the main lid, and push the
holders until they click into place.
Removable steam valve is located on the upper lid of the device. To clean the valve:
1. Carefully remove the cover of the steam valve by gently pulling it up and towards yourself
holding it by the ledge.
2. Firmly turn the holder located on the bottom side of the valve counterclockwise (in direc-
tion of OPEN) to remove.
3. Gently remove the rubber insert out of the holder. Clean all parts of the steam valve
following Cleaning Guidelines provided. Caution! Do not twist or extend the rubber insert
to avoid its deformation.
4. Carry out the assembly in return sequence: place the rubber insert back into the holder,
match the holder slots with the ledges on the inner side of the valve and turn the
holder clockwise (in direction of CLOSE). Install the steam valve back into its slot located
on the lid of the device with the ledge facing the back.
Condensation accumulates in the special cavity around the bowl. Use cloth or tissue to remove
the condensation.
Before repeated operation or storage completely dry all parts of the appliance. Store the as-
sembled appliance in a dry, ventilated place away from heating appliances and direct sunlight.
During transportation and storage, do not expose the device to mechanical stress, that may
lead to damage of the device and/or violation of the package integrity.
Keep the device package away from water and other liquids.
V. ADDITIONAL ACCESSORIES
Additional accessories are not included into the supply package of the REDMOND RMC-M70
multicooker, they can be purchased separately. You can obtain all the necessary information on
the innovations and make an order through www.redmond.company and our authorized dealers.
20
VI. BEFORE ADDRESSING A SERVICE CENTER
Problem Possible causes
Display shows the error System error, possible control board or heat-
code: Е1 — Е4 ing element malfunction
Power cord is not connected to the appliance
and/or socket
Appliance does not switch
on Wall socket is not working properly
Power supply failure
Power supply interruption (power supply is
unstable/underrated)
There is a foreign object between the bowl
Dish is taking too long to
and the heating element (grain, food particles,
cook
debris, etc.)
The bowl is not properly positioned
Heating disk is dirty
The bowl is not properly
positioned
The lid is not closed
Inner lid and cook-
Hot steam escapes from properly; foreign object
ing bowl fail to
under lid during cooking under lid
seal hermetically
Sealing ring is dirty, de-
formed, or damaged in
any way
In case you didn't manage to eliminate the defects, please, refer to the authorized service
centre.
Environmentally friendly disposal (WEEE)
The packaging, user manual and the device itself shall be taken to the applicable
collection point for the recycling of electrical and electronic equipment. Do not throw
away the electronic waste to help protect the environment.
Old appliances must not be disposed with other household waste but must be collected sepa-
rately. Municipal disposal of recyclable wastes is free of charge. The owners of old appliances
are required to bring it to a waste facility centre. With this little extra effort, you can help to
ensure that valuable raw materials are recycled and pollutants are treated as appropriate.
This appliance is labelled in accordance with European Directive 2012/19/EU – concerning
used electrical and electronic appliances (waste electrical and electronic equipment WEEE).
The guideline determines the framework for the return and recycling of used appliances as
applicable throughout the EU.
Solution
Unplug the appliance and let cool down. Close
the lid tightly and plug in the appliance
Ensure that the power cord is connected to the
corresponding inlet on the housing of the ap-
pliance and to the socket
Connect to a properly working wall socket
Check the power supply. If not available, con-
tact local electricity supply company
Ensure that the power supply is stable. If un-
stable /underrated, contact local electricity
supply company
Unplug the appliance and let cool down. Re-
move foreign object or objects
Properly position the bowl into place
Unplug the appliance and let cool down. Clean
heating disk
Properly position the bowl into place
Remove foreign objects (grain, food particles,
debris, etc.) from under the rim, if any. Always
close the lid until it clicks into place
Check the sealing ring. Replace, if necessary