Safety Regulations; Proper Use - EINHELL RT-TS 2031 U Originalbetriebsanleitung

Anleitung_RT_TS_2031_U_SPK1__ 07.08.14 13:51 Seite 16
GB
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (1-3)
1 Sawing table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
7 Universal stop
8 Hand crank
9 Tool hook
10 Additional table
11 Switch/plug block
12 Clamping screw
13 Extractor hose
14 100 mm diameter extractor connection
15 Chassis
16 Push handles
17 Chip box
18 Legs
19 Leg with opening
20 Clamping rail
21 Mounting for extractor hose
22 Mounting for wheels
23 Guide rail for cross stop
24 Struts
25 Rubber feet
26 Motor
27 Thumb screws
16
3. Items supplied (Fig. 1-4)
Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Original operating instructions
n
Safety instructions
n
Bench circular saw
n
Carbide-tipped saw blade
n
Universal stop
n
Push stick
n
Additional table
n
Tools
n
Chassis
n
Installation material
n

4. Proper use

The bench-type circular saw is designed for the
slitting and cross-cutting (only with the cross stop) of
all types of timber, commensurate with the machineʼs
size. The machine is not to be used for cutting any
type of round wood.
The machine is to be used only for its prescribed
purpose.
Any other use is deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that
result from such misuse. The machine is to be
operated only with suitable saw blades (saw blades
made of HM or CV) It is prohibited to use any type of
HSS saw blade and cutting-off wheel. To use the
machine properly you must also observe the safety
regulations, the assembly instructions and the
operating instructions to be found in this manual.
All persons who use and service the equipment have
to be acquainted with this manual and must be
informed about the machineʼs potential hazards. It is