Matrix TF30 Bedienungsanleitung Seite 40

IMPORTANT: Do not tighten bolts until step 3 is complete.
1
A Open HARDWARE FOR STEP 1.
B Attach LEFT CONSOLE MAST (1) to BASE FRAME (2)
using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4
T50
FLAT WASHERS (C). Tighten to 30 Nm / 22 lb-ft.
T70
C Attach LEAD WIRE (3) to CONSOLE CABLE (4) and pull lead
wire through RIGHT CONSOLE MAST (5). After pulling the lead
wire through the mast, the top of the console cable should be
located at the top of the mast. Detach and discard lead wire.
NOTE: Be careful not to pinch any wires while attaching the right
console mast.
Hardware For Step 1
Description
A Bolt
B Spring Washer
C Flat Washer
1
C
B
A
2
40
Qty
8
8
8
A Open HARDWARE FOR STEP 2.
2
B Place CONSOLE MAST BOOTS (6) on top of CONSOLE MASTS (1 & 5).
C Connect the CONSOLE CABLES (4), discard the wire ties,
and tuck the cables inside the CONSOLE MASTS (1 & 5) and
slide CONSOLE BASE (7) into CONSOLE MASTS (1 & 5).
T50
T70 D Attach CONSOLE BASE (7) to CONSOLE MASTS (1 &
5) using 4 BOLTS (E), 4 SPRING WASHERS (F) and 4
FLAT WASHERS (G). Tighten to 20 Nm / 15 lb-ft.
NOTE: Be careful not to pinch any wires while attaching the console base.
Hardware For Step 2
Description
E Bolt
F Spring Washer
3
G Flat Washer
4
7
6
5
4
4
1
Qty
4
4
4
4
G
E F
5