Installation - Mettler Toledo SevenEasy S30 Bedienungsanleitung

Installation

4. Installation
1. Unpack the meter, power adapter, electrode, electrode arm and other accessories according to the
enclosed packing list. Keep the calibration certificate in a safe place.
2. Make sure the power adapter matches your local power supply. If not, please contact your vendor.
3. Install the electrode stand:
- The electrode stand can be used in a stand-alone configuration, or
it can be attached to the instrument. The electrode arm is placed in
one of the three positions on the base. If the electrode stand is used
in a stand-alone configuration, it is recommended to use the middle
position.
Remove the appropriate lid. Use the supplied fixing screw to tighten
the connection. This concludes the installation if the electrode stand
is to be used in a stand-alone configuration.
- If the electrode stand is to be attached to the instrument, place the
base in front of you so that the base's free wing points away from
you. Remove the appropriate lid. The electrode stand can be mounted
on the left or right side of the base.
- Adjust the tension knob as required.
6 METTLER TOLEDO SevenEasy™ conductivity
Loosen
Tighten