Installation; Installing The Batteries; Fitting The Wrist Strap - Mettler Toledo SevenGo SG2 Bedienungsanleitung

3.

Installation

Carefully unpack the meter. Keep the calibration certificate in a safe place.
3.1

Installing the batteries

1. Push the button on the Battery cover in the direction of the arrow, hold the lid with two fingers and
remove it;
2. Insert the batteries in the battery compartment, as shown;
3. Replace the Battery cover, and push back the button to fix the lid in place.
Note
The IP67 rating requires the battery compartment to be perfectly sealed. The sealing ring around the Battery
cover must be replaced if it is damaged in any way (SevenGo™ Sealing Kit, 51302336).
3.2

Fitting the wrist strap

Fit the wrist strap as shown in the diagram.
METTLER TOLEDO SevenGo™ pH
51710340 Buch.indb 5
Installation
5
28.2.2006 15:40:06 Uhr