Frame Assembly - MARIMEX Comfort Aufbauanleitung

EN
Prior to assembling
NOTICE: the trampoline MUST be set up on grassed area only. Not suitable on
concrete or other hard surfaces. To assemble this trampoline, you will need the
special spring loading tool enclosed with your product.
WARNING: We recommend to use gloves during assembly to avoid pinching. It will
require at least two people in good physical condition to assemble the trampoline.
During periods of non-use, this trampoline can be easily disassembled and stored.

FRAME ASSEMBLY

Step 1
Put all frame tubes and T-tube connectors
in a circle as shown.
Step 2
The two ends of frame tube are different.
One end is smaller, the other is bigger.
To make it easy to assemble, first insert
the frame tube's bigger end into the
T connector, then insert the small end
of another frame tube into the same T
connector. Repeat until all the frame tubes
and connectors are connected.
Note: The welded tube of T tube connector
must face outside.
Step 3
Connect the leg extensions tube with
the "W" shape leg tubes as shown in the
picture. Make sure the pin locked. (Upright
tube not required on 8ft trampoline range).
Step 4
Place all leg tubes inside the frame circle to
line up with T-tube connectors.
55