MARIMEX Comfort Aufbauanleitung Seite 56

Step 5
Lift up the frame on one
side and insert leg tube
into T-tube connector.
Repeat this step to connect
rest of leg tubes and T -
tube connectors together.
Note: Two or more persons
are required to lift the
frame on the opposite side.
Step 6
To prepare the bounce mat to be
attached to the trampoline you must
first attach the steel hooks. Each hook
connects through 3 loops of the bounce
mat. You can find blue dots on the
bounce mat, choose one blue dot as
the start point to connect the hooks.
Working to the left or right of the
start section you connect the hooks by
pushing through 3 elasticated hoops on
the bounce mat mesh. Hold the hook
with the round hook section facing
towards you and the hook facing down.
Then thread the loop downwards through the first hoop, upwards through the
second and then finally downwards through the third loop. All hoops should now
be connected over the bar of the hook.
Step 7
Put the beginning and end overlap
together. The hook goes through 6pcs
elastic mesh only at this place. Lay the
jumping mat inside the frame. Ensure
that bounce mat faces upwards with the
cross / logo facing where entrance will be
positioned.
56