Frame Assembly - MARIMEX Comfort Spring Aufbauanleitung

Prior to assembling
NOTICE: The trampoline is not intended to be buried into the ground. The
trampoline MUST be set up on flat grassed area only. Not suitable on concrete or
other hard surfaces. To assemble this trampoline, you will need the special spring
loading tool enclosed with your product.
Do not move the trampoline after assembly. The tension of the springs can deform
the frame. If you need to
move the trampoline only, it absolutely necessary to have at least 5-6 people
evenly distributed around the trampoline, and that they all lift and move the
trampoline together. We recommend to place the trampoline on a level surface
at least 2 m from any structure or obstruction such as a fence, garage, house,
overhanging branches, laundry lines or electrical wires. Trampolines shall neither
be installed over concrete, asphalt or any other hard surface nor at proximity of
other conflicting installations (e.g. paddling pools, swings, slides, climbing frames).
Modifications made by the consumer to the original trampoline (e.g. the adding of
an accessory) shall be carried out according to the instructions of the manufacturer.
WARNING: We recommend to use gloves during assembly to avoid pinching. It will
require at least 2-3 people in good physical condition to assemble the trampoline.
During periods of non-use, this trampoline can be easily disassembled and stored.

FRAME ASSEMBLY

Step 1
Arrange the frame tubes (parts 1-4) as
rectangular as shown. Caution - the bend
of part no. 2 must point outwards and the
frame holes upwards. Connect the tubes in
the order shown.
Step 2
Connect the leg extensions tube with
the "W" shape leg tubes as shown in the
picture. Make sure the pin locked. Assemble
all trampoline legs in the same way.
46