System Tester; Functions Of Leds A And B; Terminal Strip - Bosch KTS 5-Serie Originalbetriebsanleitung

3.5

System tester

3.5.1 Diagnosis terminals/Measurement terminals
max. 60V
CH1
CH2
3
1 2
Fig. 1: Diagnosis terminals/Measurement terminals
1 Measuring input CH2 (only for KTS 570)
2 GND socket
3 Measuring input CH1(–)
4 Measuring input CH1(+)
5 Connection OBD diagnosis cable (DIAG)
3.5.2

Terminal strip

15V DC
1
Fig. 2: Terminal strip
1 Power supply connection
2 LED A and LED B (see chap. 3.5.3)
3 USB connection
Robert Bosch GmbH
Description of unit | KTS 530 / 540 / 570 (KTS 5 Series) | 21
DIAG
459802/12 Ko
4 5
USB
A B
459802/11 Ko
2 3
3.5.3

Functions of LEDs A and B

Status LED A
KTS 5xx ready for Does not illuminate
operation
Data communica- Flashes green
tion with the con- (irregular)
troller
Firmware update Does not illuminate
in operation
LED A Function
Does not illumi- No data communi-
nate cation with the con-
troller
Flashes green Data communication
(irregular) with the controller
Illuminated green Fault in hardware/
Firmware
Illuminated red Power supply
> 35 Volt.
LED B Function
Does not illumi- Voltage not present
nate
Flashes green KTS 5xx ready for op-
(1 second inter- eration
val)
Illuminated green Fault in hardware/
Firmware
Flashes yellow Overvoltage on
(1 second inter- diagnostic cable
val)
Illuminated yellow Fault in hardware/
Firmware
Flashes red Firmware update
(irregular) in operation
Illuminated red Fault in firmware-
update
Unplug the USB connection and power supply and connect them
*)
again. If the error still exists, contact customer service.
en
LED B
Flashes green
(1 second interval)
Flashes green
(1 second interval)
Flashes red
(irregular)
Measures
Check connection
with the controller
None
*)
Check voltage in ve-
hicle
Measures
Check power
supply
None
*)
*)
*)
None
Repeat firmware
update
|
1 689 989 289 2014-12-04