System Tester; Diagnosis Terminals/Measurement Terminals; Connection Panel; Status Display (Leds) - Bosch KTS 5a Serie Originalbetriebsanleitung

3.5

System tester

3.5.1

Diagnosis terminals/Measurement terminals

1 2
Abb. 1: Diagnosis terminals/Measurement terminals KTS 560
1 Measurement input CH1(–), blue
2 Measurement input CH1(+), yellow
3 Connection for OBD connecting cable (DIAG)
1 2 3 4
Abb. 2: Diagnosis terminals/Measurement terminals KTS 590
1 Measurement input CH2(+), red
2 Measurement input CH2(–), black
3 Measurement input CH1(–), blue
4 Measurement input CH1(+), yellow
5 Port for OBD connection cable (DIAG
3.5.2

Connection panel

1 2
Abb. 3: Connection panel
1 Memory card slot (not functional)
2 Power supply unit connection
3 USB port
4 Bluetooth USB adapter (plugged in at the factory)
Robert Bosch GmbH
Device description | KTS 560 / 590 (KTS 5a Series) | 17 | en
3
459963-03_Ht
5
459963-05_Ht
3 4
459963-06_Ht
Abb. 4: Connection panel with protective cap
i
The protective cap included in the scope of delivery
protects the connection panels against mechanical
damage, soiling or water.
3.5.3

Status display (LEDs)

1 2
6
Abb. 5: Status display (LED)
1 ON/OFF LED
2 ERROR LED
3 USB LED
4 BLUETOOTH LED
5 DIAGNOSTICS LED
6 "Recovery mode" key
ON/OFF LED Function
Green light KTS 560 / 590 is ready for operation.
Flashing KTS 560 / 590 is only connected via the USB
green connection cable (power supply via mains
adapter or OBD connection cable is missing).
KTS 560 / 590 is not ready for use.
Off No voltage supply.
ERROR Function
LED
Off No error
Red light Hardware/firmware prob-
lem
Voltage supply > 36 V
"Recovery mode" activated
3 4 5
459963-09_Ko
Measure
None.
Remove the USB
connection cable
and voltage supply
and reconnect.
Perform firmware
update.
Test the power sup-
ply.
Carry out recovery.
|
1 689 989 223 2019-03-04