Description Of Unit - Bosch KTS 5-Serie Originalbetriebsanleitung

2.6 Important information regarding
Bluetooth
Bluetooth is a wireless connection in the unlicensed
2.4 Ghz-ISM-Band (ISM: Industrial, Scientific, Medical).
This frequency range is not subject to any governmen-
tal laws and may be used in most countries without a
license. This results in many applications and devices
transmitting on this frequency band however. This can
cause frequency interference between these devices.
Depending on the environmental conditions, distur-
bance can occur in the Bluetooth connection, e. g. in
WLAN connections (WLAN: Wireless Local Area Net-
work), wireless telephones, radio-controlled thermom-
eters, radio-controlled garage door openers, radio-con-
trolled light switches or radio-controlled alarm systems.
i
Bluetooth can lead to interference in the band-
width of the WLAN-network. The antennas of Blue-
tooth and WLAN devices should be positioned at least
30 centimeters apart. Bluetooth-USB adapters and
WLAN must not be placed in adjacent USB sockets in
the PC/Laptop. A USB extension cable (special acces-
sories) should be used to ensure that the Bluetooth-
USB adapter is separate from the WLAN stick.
i
Generally, people who wear a pacemaker or other
essential electronic device should exercise extreme
caution when using wireless technology, as it may
impair the function of their particular device.
Note the following to ensure that your connectivity is as
good as possible:
R
The Bluetooth wireless signal always looks for the
shortest path. Set up a PC/Laptop with Bluetooth
USB adapter so that there are as few obstacles,
such as e. g. steel doors and concrete walls, that
could disturbed the radio signal to and from the
KTS 540 / 570 as possible.
R
If the PC is in a Bosch trolley (e. g. FSA 760,
BEA 950), the Bluetooth USB adapter should be po-
sitioned outside of the trolley using a USB extension
cable. Use USB extension cable (special accessory)
1 684 465 564 (1 m) or 1 684 465 565 (3 m).
R
If there are problems with the Bluetooth connec-
tion, you can activate the USB connection and use it
instead of the Bluetooth connection.
R
It is not possible to operate another piece of bluetooth
hardware installed or plugged into the PC/laptop, as
the data communication between the KTS 540 / 570
and the control unit would be disrupted as a result.
Robert Bosch GmbH
Description of unit | KTS 530 / 540 / 570 (KTS 5 Series) | 19
3.

Description of unit

3.1 Application
KTS 530, KTS 540 and KTS 570 (hereinafter referred to
as KTS modules) are modules for controller diagnosis.
The functionality differences are shown in the following
table:
Function
Controller diagnosis
1 channel multimeter
2 channel multimeter
2 channel oscilloscope
2 channel diagnosis
oscilloscope
Bluetooth wireless
connection
USB connection
KTS modules can perform the following functions with
ESI[tronic] or ESI[tronic] 2.0:
R
Controller diagnosis, with e.g.
$
Read error memory
$
Display actual values
$
Initiate actuators
$
Use of other controller-specific functions
R
Multimeter measurements for
$
Voltage measurement
$
Resistance measurement
$
Current measurement (only with special acces-
sory current measuring clips or shunt)
R
2 channel oscilloscope for determining measure-
ment values (KTS 570 only).
R
2 channel diagnosis oscilloscope for testing the
controller diagnosis interface (KTS 570 only).
en
KTS 530 KTS 540 KTS 570
x x x
x x x
– – x
– – x
– – x
– x x
x x x
|
1 689 989 289 2014-12-04