Bosch KTS 5-Serie Originalbetriebsanleitung Seite 26

en 26 | KTS 530 / 540 / 570 (KTS 5 Series) | Initial start-up
4.6 Notes concerning faults
i
In the case of transmission problems during control
unit diagnosis, please observe the notes in Sections
2.6, 3.6.2 and 4.6.3.
4.6.1 Diagnosis hardware has not been found
When the on-board diagnosis software was
started or during communication with the con-
trol unit, no diagnosis so diagnosis hardware
(KTS 530 / 540 / 570 (KTS 5 Series)) was found. The
fault message " Connect diagnosis hardware
and supply it with external voltage
Wireless connection to the KTS module is
"
faulty ".
Possible causes What can you do
No external voltage Check whether the KTS module has an ex-
supply. ternal voltage supply
(power pack or OBD diagnostics cable).
LED B on the KTS module must be flash-
ing green.
KTS module not 1. Terminate on-board diagnosis
active or incorrectly 2. Start the DDC ("Start >> Settings >>
configured. Control panel").
3. In the DDC, check whether the KTS
module is correctly configured and has
been activated.
4. Finally, test the KTS module.
Bluetooth
Bluetooth manager symbol
connection
flashing white or white/green or
faulty or non-exis-
1. Reduce the gap between the Bluetooth
tent (e.g. according
USB adapter and KTS 540 / 570.
to standby model of
2. If the Bluetooth USB adapter is used on
the PC/Laptop).
different PC/laptop USB connections,
the Bluetooth driver installation must be
carried out on each USB connection.
3. Test KTS 540 / 570 in the DDC.
4. If the Bluetooth connection does not
test OK, initialize Bluetooth drivers
(see Chapter 4.6.3).
5. Reboot PC/laptop.
No Bluetooth USB
Bluetooth manager symbol
adapter.
1. Plug in the Bluetooth USB adapter.
2. Re-start the control unit diagnosis.
4.6.2 No communication with the control unit
During the on-board diagnosis, the following fault mes-
No communication with the con-
sage appears: "
trol unit. Adapter lead connected?
Possible causes What can you do
Incorrect lead connected. Check if the correct lead has been
used.
i
If problems of a different nature occur, please con-
tact the ESI[tronic] service hotline directly.
|
1 689 989 289 2014-12-04
4.6.3 Initializing Bluetooth drivers
i
If the Bluetooth USB adapter is used on different
PC/laptop USB connections, the Bluetooth driver
installation must be carried out on each USB con-
nection.
If the Bluetooth connection is faulty or absent or alter-
native remedial measures failed (see Chapter 4.6.1),
the Bluetooth drivers must be initialized.
Proceed as follows:
" or 1. Double-click on the Bluetooth manager icon
 Bluetooth settings will open.
red.
i
If the "Add New Connection Wizard" dialog window
opens, continue from Item 4.
red
2. Check whether KTS 540 / 570 appears under the
entered Bluetooth devices.
3. If no KTS 540 / 570 is entered: select
<New connection> and then proceed from Item
3. If KTS 540 / 570 is entered: delete KTS 540 / 570.
$
" If KTS 540 / 570 is connected
"Bluetooth >> Disconnect" menu option.
$
Select "Bluetooth >> Delete".
$
Select <New connection>.
 "Add new Connection Wizard" dialog window will
open.
or
.
:Select
Robert Bosch GmbH