Hubs Adjustment - CAMPAGNOLO HYPERON Bedienunganleitung

7. HUBS ADJUSTMENT

• Using a stiff blade (such as small knife) positioned as indicated in Fig. 1 (page 13) and taking care not to damage the hub or the spokes, remove
the side covers from the hub.
• Align the screw (A - Fig. 1) of the lock ring (B - Fig. 1) with the groove (C - Fig. 1) on the hub body.
• Fully insert the 2.5 mm Allen wrench (D - Fig. 2) into screw (A - Fig. 2) and tighten it by about three (3) turns.
• To reduce axle clearance, tighten lockring (B - Fig. 2) by turning it clockwise by hand or with a 21 mm wrench.
• To increase axle clearance, loosen lockring (B - Fig. 2) by turning it counter-clockwise by hand or with a 21 mm wrench.
Strike screw (E - Fig. 3) lightly with the plastic handle of the Allen wrench.
• Tighten the Allen screw (A - Fig. 2) with the wrench properly seated on it until the gap (X - Fig. 2) on the lockring (B - Fig. 2) is completely closed.
• Make sure that the adjustment is correct (the axle slides easily and without play), otherwise repeat the adjustment procedure.
1
A
B
C
2
A
B
X
OPEN
CLOSE
OPEN
3
CLOSE
D
E
19