CAMPAGNOLO HYPERON Bedienunganleitung Seite 30

• Slide out the spoke to be replaced (H - Fig. 8) from the hub.
• Insert the new spoke (I - Fig. 9) in the hole in the hub, insert the
plate and retighten the nut.
WARNING!
when fitting the wheel, check that the plates remain
in position (see Fig. 3, page 18) since an incorrectly
positioned plate may caused irreparable damage to the profile
of the rim when tensioning the spokes. This damage could cause
the rim to unexpectedly fail, resulting in an accident (Fig. 10).
• Refit the hub, performing disassembly operations in reverse order.
Attention.
When inserting the axle, be careful not to move the ball bearings out
of their seats.
Attention.
After completing the operation, check that the flat spoke (aero) is
oriented in an aerodynamic position (Fig. 4 - Pag. 6).
Following the operations described in Section 5 of the "Owner's
Manual - PART 1":
• Tighten and Settle the Spokes.
• Check centering and wheel dishing.
• After having replaced the spoke and tensioned and centered the
wheel, adjust the hub (see section 7).
8
H
10
9
I
OK! NO!
9