CAMPAGNOLO HYPERON Bedienunganleitung Seite 38

• Position the freehub close to the hub and hold it pressed against
the latter; lower one by one the three pawls with an Allen wrench
or a screwdriver and insert freehub fully into its seat (Fig. 12).
• Tighten the locking nut (E - Fig. 13) with a 17 mm wrench, holding
the axle axle steady from the freehub side with a snugly fitted
5 mm Allen wrench (approximate torque setting: 15 N.m - 11 lb.ft.).
• Adjust the hub as illustrated in section 7.
12
13
E
CLOSE
15 N.m - 11 lb.ft
17