Replacing A Spoke - CAMPAGNOLO HYPERON Bedienunganleitung

5. REPLACING A SPOKE

5.1 - FRONT WHEEL AND REAR WHEEL ON THE SIDE
OPPOSITE THE FREEWHEEL.
• Before proceeding with assembly, check in the technical specifications
on page 3 the type and length of the spoke to be replaced, the
recommended value and the maximum value which must not be
exceeded when tightening the spokes.
• Check that there are no residues of sand or any other foreign
material inside the rim and, if necessary, remove them with a jet of
compressed air.
• Obtain an original Campagnolo replacement spoke.
• Always prevent the rotation of the spokes when nuts are tightened
or loosened. Make sure that no damage is caused to the surface
of the spokes.
CAUTION!
Take special care when handling the spokes during
assembly to prevent accidentally scratching the rim.
• Using a 5 mm hex wrench, completely unscrew the nut of the
spoke to be replaced (Fig. 1), holding the latter steady to prevent
rotation.
• Remove the nut and plate, then slide the spoke out of the rim (Fig. 2).
• Using a stiff blade (such as small knife) positioned as indicated in
fig. 3 and taking care not to damage the hub or the spokes, remove
the side covers (A) from the hub.
1
5 mm
3
A
2
A
7