CAMPAGNOLO HYPERON Bedienunganleitung Seite 33

• Insert the new spoke in the specific seat in the hub, turning the
thicker side (X - Fig. 5) of the cable end (A - Fig. 5) towards the
inside.
• If necessary, reposition the overlapping spoke, making sure that
the overlap is correct where the two meet.
• Slightly open the spoke retainer ring, then refit it (Fig. 6).
Attention.
After completing the operation, check that the flat spoke (aero) is
oriented in an aerodynamic position (Fig. 7).
Following the operations described in Section 5 of the "Owner's
Manual - PART 1":
• Tighten and Settle the Spokes.
• Check centering and wheel dishing.
• After having replaced the spoke and tensioned and centered the
wheel, adjust the hub (see section 7).
12
5
X
A
6
7