CAMPAGNOLO HYPERON Bedienunganleitung Seite 32

• Remove the spoke together with the cable end (A - Fig. 3).
CAUTION!
If necessary, first lift the spoke overlapping the one
to be replaced and, after assembly of the new spoke,
make sure it is returned to exactly the same position.
• Insert the new spoke in the hole on the rim, insert the plate positioning
the longest side longitudinally compared with the rim rotation
direction, then tighten the nut (Fig. 4).
WARNING!
When fitting the wheel, check that the plates remain
in position since an incorrectly positioned plate may
caused irreparable damage to the profile of the rim when
tensioning the spokes. This damage could cause the rim to
unexpectedly fail, resulting in an accident (Fig. 4).
3
A
OK! NO!
4
11