Agilent Technologies Special Turbo-V 1K-G Bedienungshandbuch Seite 202

16 Instructions for Use
Pump Fixing
Tab. 1
FLANGE
ISO 160 F
The class of the steel screws for "F" flange must be > 8.8
The Special Turbo-V 1K-G can be installed in any position.
The Special Turbo-V 1K-G cannot be fixed by means of its base.
NOTE
CAUTION! The Special Turbo-V 1K-G belongs to the second installation (or overvoltage)
category as per directive EN 61010-1. Connect the device to a mains line that
satisfy the above category. The Special Turbo-V 1K-G has Input/Output and
serial communication connectors that must be connected to external circuits in
such a way that no electrical part is accessible. Be sure that the insulation of
the device connected to the Special Turbo-V 1K-G is adequate even in the case
of single fault as per directive EN 61010-1.
For installation of optional accessories, see "Technical Information".
202/258 Special Turbo-V 1K-G User Manual / 87-901-006-01 (A)
N. FIXING TORQUE
8 5 Nm