Bottom Mounting - Agilent Technologies Special Turbo-V 1K-G Bedienungshandbuch

17 Technical Information
Special Turbo-V 1K-G Navigator Controller
Installation

Bottom Mounting

See the following figure.
1
2
3
4
5
6
7
Figure 37
248/258
Turn the pump upside-down;
Place the three washers on the pump bottom in correspondence
of three hole at 120°;
Place the controller on the washers, with the pump cable toward
the pump body;
Fix the controller to the pump bottom by means of the three
socket head screws M5;
Turn the pump again;
Plug the line card and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
Special Turbo-V 1K-G User Manual / 87-901-006-01 (A)