Saving Stations Manually - Silvercrest SBDB 5 A1 Bedienungsanleitung Und Sicherheitshinweise

♦ Press the TUNE+
the display
♦ Press the
display
multiplex numbers and frequencies .
♦ Press the TUNE+
♦ Press the
The display
♦ Move the screw aerial
improve the signal strength of a station .
Pay attention to the bar graph showing the signal strength . For optimum
signal strength, the bars should be as high as possible .

Saving stations manually

♦ Press the TUNE+
from the station list .
♦ Press the PRESET button
the station preset with the last selected radio station (if radio stations have
already been stored) . If no radio stations have yet been stored, the dis­
play
♦ Press the TUNE+
♦ Press the
preset space . The preset space of the stored station is shown in the upper
right corner of the display
NOTE
► Stored radio stations are overwritten if you store other stations in station
presets that are already occupied .
Calling up saved stations
♦ Briefly press the PRESET button
in the station presets . Preset ReCall appears on the display
♦ Press the TUNE+
in the station presets . After approx . 2 seconds, the displayed station plays
automatically . Alternatively, briefly press the
button
■ 50 │ GB │ MT
or TUNE− button
9
.
1
ENTER / SCAN button
shows the receivable DAB+ radio stations with the respective
1
or TUNE− button
9
ENTER / SCAN button
shows the station signal strength as a bar graph .
1
i
or TUNE− button
9
7
shows Preset Store preset 1 empty .
1
or TUNE− button
9
ENTER / SCAN button
1
or TUNE– button
9
to listen to the selected station .
3
until Manual tune appears on
8
to confirm the selection . The
3
to select a station .
8
to confirm the selection .
3
or change the setup location of the device to
to select a DAB+ radio station
8
for about 2 seconds . The display
to select the desired preset .
8
to store the station in the selected
3
(e .g . P1 for preset 1) .
7
to call up the DAB+ radio stations stored
to select a radio station stored
8
shows
1
.
1
ENTER / SCAN
SBDB 5 A1