Cleaning And Care; Storage - Silvercrest SDM 800 A1 Bedienungsanleitung

Note:
If you put too much pastry into the donut moulds it is
possible that, during the baking process, the closure
of the lid could pop open and the baking surfaces
are pressed apart. In this case, use less pastry for
the next baking process.
5. After no less than 2 minutes you can open the lid
to check the baking result. Opening the lid earlier
will only tear the donuts. To ones own taste, the
donuts are ready after ca. 2 - 3 minutes.
Note:
When removing the donuts ensure that you do not
damage the coating of the baking surfaces. If you
do, it will become harder to separate the donuts
from the surfaces.
6. After baking the last donut remove the plug
from the power socket and allow the appliance
to cool with the lid open.

Cleaning and care

Important!
Never open the housing of the appliance. There are
no operating elements inside. When the housing is
open, there is the risk of receiving a fatal electrical
shock. Before cleaning the appliance, ....
• Remove the plug from the power socket and allow
the device to cool down completely.
Under no circumstances may the components
of the appliance be submerged in water or
other liquids! There would be the risk of a fatal
electric shock upon the next use of the appli-
ance should moisture be present in the voltage
conducting elements .
Attention! Property damage!
• Do not use detergents or solvents. They could not
only damage the appliance, they can also leave
traces that would be baked into the next donuts.
• First of all, clean the baking surfaces with a dry
paper towel to soak up the grease residue.
• Then clean all surfaces and the power cable
with a lightly moistened cloth. Always dry the
appliance well before using it again.
In the case of stubborn residues:
Attention! Property damage!
NEVER make use of hard objects. These could da-
mage the coatings of the baking surfaces.
• It is better to lay a wet wash cloth on the encrusted
residues in order to soften them.

Storage

Allow the appliance to cool off completely before
putting it into storage.
Wind the power cable around the cable retainer
on the bottom of the appliance.
Store the appliance in a dry location.
- 4 -
w