Trouble Shooting; Fault Correction - FLORABEST FHT 600 D3 Originalbetriebsanleitung

Trouble Shooting

Problem
Device does not start
Device runs with inter-
ruptions
Blades become hot
Possible cause
Mains voltage not on
On/Off switch (
defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (
defective
Blades are blunt
Blades are notched
Too much friction due to
lack of lubrication

Fault correction

Check plug socket, cable, line and
plug, where appropriate, have re-
paired through electrical specialist
6)
Repair by Service Centre
Check the cable and have it
changed by the Service Centre if
necessary
Repair by Service Centre
6)
Have the blades (
or replaced (Service Centre)
Have the blades (
replaced (Service Centre)
Oil the blades (
GB IE
2) sharpened
2) checked or
2)
13