Fan Belt; Lift Cylinders; Specific Torque Requirements - Textron Jacobsen Greens King IV Plus Sicherheits-, Bedienungs- Und Wartungshandbuch

9.17 FAN BELT ________________________________________________________________

Inspect and adjust new belt after first ten hours of
operation. Adjust every 100 hours thereafter.
1. Adjust alternator pulley so belt (B) deflects 9/32 to
11/32 in. (0.7 to 0.9 cm) with a 22 lb. (10 kgf) push at
mid span between pulleys.
2. If tension is incorrect, loosen alternator mounting
bolts (A) and adjust alternator until proper belt
tension is achieved. Tighten hardware (A).

9.18 LIFT CYLINDERS __________________________________________________________

1. Fully extend the front cylinder, then check spacing
at the cam roller (U). The dimension should be 7/16
to 9/16 in. (1.11 to 1.42 cm).
2. Loosen nut (V) then grip the very end of the cylinder
rod, close to the adjusting nut (point W) and turn
until spacing is correct. Tighten nut (V).
3. Loosen nut (X) on the rear lift cylinder. Adjust the rod
end (Y) until the lift arm (O) just touches the stop
bracket when the cylinder is fully retracted.

9.19 SPECIFIC TORQUE REQUIREMENTS _________________________________________

1. Ball joints: 30 - 35 ft. lb., (40.5 - 47.2 N.m).
2. Bedknife shoe: 25 - 37 ft. lb., (34 - 50 N.m).
3. Brake drum and hub to wheel motor: 90 - 100 ft. lb.,
(122 - 135 N.m).
4. Steering wheel nut 25-30 ft. lb., (34-41 N.m).
U
7/16 to 9/16 in.
(1.11 to 1.42 cm)
Stop Bracket
O
5. Steering cylinder ball joints (2): 50 - 55 ft. lb., (67.5 -
74.2 N.m).
6. Wheel mounting hardware 65-85 ft. lb., (88 - 115
N.m). Check and retorque daily until torque is
maintained.
ADJUSTMENTS
A
B
Figure 9P
W
Figure 9Q
X
Y
Figure 9R
9
V
GKV-8
GKV-9
47