How To Connect The Outputs Of The Controller; J6 - Serial - Agilent Technologies TV 301 Navigator Bedienungshandbuch

How to Connect the Outputs of the Controller

The following figure shows a typical logic output connection (relay
coil) but any other device may be connected e.g. a LED, a computer,
etc., and the related simplified circuit of the controller. The figure
example refers to the programmable set point signal on pins 11 and 9.
Figure 24
J6 – Serial
Figure 25
This is a 9 pin D-type serial input/output connector to control via an
RS 232 or RS 485 connection the TV 301.
TV 301 Navigator User Manual / 87-900-946-01
How to Connect the Open Collector Inputs of the Controller
9 pin connector
(M)
Technical Information
239/282
17